fbpx

Youth 1000

YOUTH 1000 UTV
Limited Youth Normally Aspirated 1000 UTV
* Updated May 11th, 2020 *

Click here to download a printable PDF.

DEFINITION
Two seat vehicles built using a Normally Aspirated production UTV. Any manufacture UTV may be used providing the model used has been series produced in a minimum of 1000 units within a twelve(12) month period. Maximum engine size 1000cc. Driver must be at least twelve (12) years old. Maximum age is seventeen(17) years old.

*Racers under the age of twelve(12) will be considered on a case-by-case basis.

GENERAL REGULATIONS
Entrants in this class shall comply with all applicable general regulations.

TECHNICAL REGULATIONS
This class is a stock production class and all components must remain stock except for those modifications allowed herein.

NOTE: The UTR abbreviations listed under this class (I.E. UTR1 HELMETS) refer to UTR cross reference listings in the front of this book. These UTR cross-referenced listings are part of the class rules. Where a conflict occurs between the UTR cross-referenced listing and a rule contained under this class, the rule contained under this class takes priority.

SAFETY EQUIPMENT

UTR1 HELMETS
UTR2 PROTECTIVE CLOTHING
SFI-A5 rated fire suits are required. No karting suits.

UTR3 EYE PROTECTION and DENTURES
UTR4 HEAD AND NECK RESTRAINTS

SUSPENSION COMPONENTS

UTR11 SHOCK ABSORBERS and BUMP STOPS
UTR12 SECONDARY SUSPENSION
UTR13 WHEELS and TIRES
UTR14 FASTENERS

STEERING and BRAKE COMPONENTS

UTR15 STEERING
UTR16 BRAKES

ELECTRICAL SYSTEM

UTR17 IGNITION
UTR18 BATTERIES
UTR20 STARTERS

FUEL SYSTEM

UTR21 FUEL
UTR22 FUEL TANKS
UTR23 FUEL FILLERS LINES, VENTS, and CAPS

ENGINE, TRANSMISSION and DRIVELINES

UTR24 ENGINE and ENGINE DISPLACEMENT
Engines must remain stock as delivered by the manufacturer. ECU programming is open.

UTR25 ENGINE REPLACEMENT
UTR26 TRANSMISSION
UTR27 THROTTLES
UTR28 EXHAUST
Open

UTR29 DRIVE SHAFTS
UTR31 FLUID COOLERS

VEHICLE SAFETY EQUIPMENT

UTR34 ROLL CAGES
Aftermarket roll cage required. No stock cages.

UTR35 SAFETY HARNESS
UTR36 SAFETY NETS
UTR37 SEATING
Seating must retain stock configuration.

GENERAL VEHICLE COMPONENTS

UTR38 DRIVERS COMPARTMENT
UTR39 DOORS AND LATCHES
UTR40 FIREWALLS
UTR41 BALLAST
UTR42 WEIGHT
1500 minimum.

UTR43 FLOORBOARDS
UTR44 BUMPERS and HAZARDOUS PROTRUSIONS
UTR45 MIRRORS
UTR46 SKID PLATES
UTR47 STORAGE
UTR48 CHASSIS and BODY
Roof panel required. Must be a minimum of .060 thick metal.

UTR49 HOSES
UTR50 IDENTIFICATION MARKINGS
Race numbers required on both sides and rear of the vehicle. Black numbers on a white background only. Minimum six(6) inch tall numbers.
UTVWC will assign race numbers.

UTR51 ADVERTISING on VEHICLES
UTR52 RADIO EQUIPMENT
UTR53 WORKMANSHIP
UTR54 TRACKING DEVICE